ISONIC EXPERT CU software application was created for the inspection of longitudinal welds with symmetrical bevel in the tubes, vessells, and the like with use of wedged linear array probes situated on the OD surface of the parent material

ISONIC EXPERT CU IN software application was created for the inspection of longitudinal Welds with symmetrical bevel in the tubes, vessells, and the like with use of wedged linear array probes situated on the ID surface of the parent material

Both inspection software options are available for the ISONIC 3510, ISONIC 2010, and ISONIC 2009 UPA Scope instruments and featured with:
Built-In Weld Geometry Editor and Ray Tracer - Scanning Pattern (Scan Plan) Design
Automatic Curvature Correction for the wedges with contoured contact face
Intuitive Image Guided PA Pulser Receiver with Beam Forming View
True-To-Geometry Weld Overlay Volume Corrected Imaging - Cross Sectional and Top (C-Scan)- / Side- / End- View and 3D through Sector-Scan Cross Sectional Coverage and line scanning along the fusion line either encoded or time based
DAC / TCG Data / Image Normalization
Independent on TCG Angle Gain Compensation / Gain Per Focal Law Correction
Automatic Coupling Monitor
100% Raw Data Capturing
Automatic Defects Alarming Upon C-Scan Acquisition Completed
Automatic Creation of Editable Defects List
Comprehensive Postrpocessing Toolkit Including:
Recovery and Evaluation of the Captured A-Scans from the Recorded Cross Sectional Views (Sector Scan) and C-Scans
Recovery of the Cross Sectional Views from the Recorded C-Scans
Converting Recorded C-Scans or their Segments into 3D Images
Off-Line Gain Manipulation
Off-Line DAC Normalization of the Recorded Images / DAC Evaluation
Numerous Filtering / Reject Options ( by Geometry / Position / By Amplitude db-toDAC / etc ) and Regeneration of the Corresponding of Editable Defects List and Storing it into a Separate FIle
Defects Sizing
Automatic creating of inspection reports - hard copy / PDF File