ISONIC DRILL ROD software application was created for the inspection of the drill rods for the transversal cracks and other surface defects with use of PA probe situated on the end surface of the part

This inspection software option is available for the ISONIC 3510, ISONIC 2010, and ISONIC 2009 UPA Scope instruments and featured with:
Built-In Drill ROd Geometry Editor and Ray Tracer - Scanning Pattern (Scan Plan) Design
Intuitive Image Guided PA Pulser Receiver with Beam Forming View
True-To-Geometry Drill Rod Overlay Volume Corrected Imaging - Cross Sectional Anlong the Shaft, Bolt, Spindle, etc / Unfolded C-Scan / 3D through the Sector-Scan Cross Sectional Coverage and probe rotation scanning around the end surface of the part
DAC / TCG Data / Image Normalization
Independent on TCG Angle Gain Compensation / Gain Per Focal Law Correction
Automatic Coupling Monitor
100% Raw Data Capturing
Automatic Defects Alarming Upon C-Scan Acquisition Completed
Automatic Creation of Editable Defects List
Comprehensive Postrpocessing Toolkit Including:
Recovery and Evaluation of the Captured A-Scans from the Recorded Cross Sectional Views (Sector Scan) and C-Scans
Recovery of the Cross Sectional Views from the Recorded C-Scans
Converting Recorded C-Scans or their Segments into 3D Images
Off-Line Gain Manipulation
Off-Line DAC Normalization of the Recorded Images / DAC Evaluation
Numerous Filtering / Reject Options ( by Geometry / Position / By Amplitude db-toDAC / etc ) and Regeneration of the Corresponding of Editable Defects List and Storing it into a Separate FIle
Defects Sizing
Automatic creating of inspection reports - hard copy / PDF File